Power press machine manufacturer and supplier today? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. Find extra info on https://www.pressmachine-world.com/power-press-machine. Through this partnership of shared experience and ideas, we are confident that we can realize your current and future requirements on WORLD press machine.

The imprint bending is the same as the bending of the bottomed die, except that the front end of the punch is processed to the required bending radius, and the gap between the punch and the die at th bottom of the stroke is smler than the material thickness. Since enough presure approximately 10 timesof fee bendig is applied to force the front end of the punchto contact the material, springback is basically avoided.

Structures of hydraulic press brake machinesThe hydraulic press brake is an important equipment for the bending and forming of wokieces in the shet meta instry It functionis to press the telplate into parts of various shapes according to the process requirements. The frame is mainly composed of lf an right columns, wokbenches, and beams. Teleft and right oil cylinders are ied on th colms. The slider is connected with the pistons of th oil cylinders. The lower mold is tixed on the worktable. The upper punches are installed athe lower end of the slider. The hydraulic system provides power, and the electrical system gives instructions. Under the action of the oil cylinder, the slider drives the upper mold downwards and closes the lower mold to realize the folding of the sheet. The lett andrght columns, the workbench and the sliding block hereinafter refere to as h three major parts)are the key parts of the bending machne. The tl weighto te three major parts accounts for 70% to 80% of the total weight of a bending machine. Its strength and rigidit directy determine the operating accuracy, service life of the machine tool, and the ccuracy of the workpiece.

As far as free bending is concerned, punch and die are procese at 85 or les (saler i better). When using this set of molds, pay attention to the ga beteen the male mold and the female mold at the bottom of the stroke, and the excessive bending that is sufficient to compensate for the springback and keep the material at about 90°. Generally, the springback angle of the free bending die on the new bending machine is s2, and the bending radis is equa to 0.156 times the opening distance of the die. For the bending of bottomed concave molds, the mold angle is generally 86 ~ 90°. At the bottom of the stroke, there should be a gap slightly larger than the thickness of the material between the male and female molds. The forming angle is improved because the bottomed die has a larger bending tonnage (about 4 times that of free bending), which reduces the stress that usually causes springback in the bending radius.

The reason for this is the significantly lower modulus of elasticity of aluminum compared to stel. However, i ore to realise reaterdegrees o defration, sale straightenig rolls must be used. With high-strength steels, on the other hand, a conflict of objectives arises. On the one hand, their high yield strengths require enormous forming forces and torques; on the other hand, small straightening rll diameters are als ned here to ahie asufficent egeo p lstificaton.The straightening o both aluminum and high-strength steels therefore requires a forming geometry adapted to the respective product. This is essentially determined by the number, diameter and spacing of the straightening rolls. Read even more details at pressmachine-world.com.