Tecna swivel electrode online store UK

Spot welding of very dissimilar metals, such as aluminum and steel, is generally not possible because of different melting characteristics and conductivities. Some types of coated low-carbon steels require special techniques. Steels plated with chrome and nickel for electrical conductivity can usually be resistance welded as readily as uncoated material. Aluminum, tin, zinc and terne-coated steels are also spot weldable with special precautions and welding equipment. Some coatings can emit poisonous fumes that must be safely handled when spot welded, thereby increasing cost. Spot welding of coated substrates creates burn marks in the coating which can be unsightly and may corrode in severe environments. Designers should carefully consider the product’s appearance and service requirements before specifying spot welding of pre-plated materials.

Start off by drilling 7.5mm holes in the front sheet of metal at a spacing of normally 25mm to 40mm (or whatever the original spot weld spacing was). Then clamp this sheet onto the back sheet. 7.5mm is a reasonably good hole size for 0.8 or 1.0mm sheet. Thicker sheet might require a slightly larger hole size. Try a little test piece out like this one before welding a whole sill onto a car and check the weld has penetrated through both sheets.

Copper and its alloys can also be joined by resistance spot welding, although spot welding copper cannot be easily achieved with conventional copper alloy spot welding electrodes, as heat generation in the electrodes and work piece are very similar. The solution to welding copper is to use an electrode made of an alloy with a high electrical resistance and a melting temperature far in excess of the melting point of copper (much greater than 1080°C). Electrode materials typically used for spot welding copper include molybdenum and tungsten. See more info at Auto Body Spot Welder.

Portable spot welders are compact, lightweight and handy for difficult-to-access joints. As such, they are most commonly used in coachbuilding. They have an average welding capacity of 2 + 2mm and are relatively inefficient due to the fact that the electrodes aren’t cooled between cycles. Automatic adjustment makes it easier to adjust the spot parameters according to the thickness of sheet and welding head used.